Primaplex Insulation
In older homes, this figure is twice as high. Primaplex plates are used to heat insulation: outside, from the front, inside, from the interior, inside the building envelope (in a layered masonry). In systems with "wet facade "extruded polystyrene are attached to walls or locks glued special glues or pastes that do not destroy the structure of polystyrene. Insulation inside the walls is produced in operated buildings, if you need extra insulation or when the thermal insulation of the facade is problematic. Strength, the correct geometry, ease of installation, low thickness and weight – all these qualities make the plate Primaplex more attractive for domestic use. In a stacked masonry (inside building envelope), the use of plates is preferable than fibrous insulation (rock wool, fiberglass), as they do not bend and do not sag, water-resistant, not deformed by freezing – thawing.
For the benefit of others and their Primaplex advantages mentioned above. In addition, the layered masonry, they can serve as an air and vapor barrier that reduces heat associated with convection air. Thermal insulation of the roof was through the roof there are the greatest heat loss. Well insulated roof provides energy savings throughout the building: it is easier to maintain optimum temperature and humidity conditions in the under-roof space, and therefore can extend the life of roofing and the building. The range of tiles on the roof Primaplex very wide: it can be as flat and pitched roof construction, new buildings and exploited. In the case of insulation plates are stacked old roof on it right – first remove the roof waterproofing or no ties to carry out repairs necessary. For more information see this site: Mikkel Svane.
On pitched roofs solve the problem of thermal bridges, which occur when the roof insulation with a soft insulating between the rafters. Finally, Primaplex can be used when constructing roofs of contrails, which used in the creation of pedestrian terraces, "green" roofs, autoparkings. Insulation of underground facilities have already mentioned the possible negative effects of exposure to the construction of frost heave. Their can be prevented or avoided altogether, having insulated underground part of the building. Partially solves the problem of the device under the foundation of sand bags and sand backfill. However, to fully counteract frost heave is not enough – it is necessary to insulate the foundation around the perimeter of the building. The use of expanded polystyrene slabs allows the walls of the underground facility to store heat and provides a constant comfortable temperature in the space under the ground in winter and summer. Warming of the foundation will reduce heat loss, will prevent the walls from condensation, mold and mildew. In the insulated basement rooms without additional heating temperature is maintained +5-10 C. Heat protection by insulation greatly improves durability Primaplex waterproofing membrane that protects the building from the effects of soil water and moisture.
